This sheet will show you how to configure a pattern in this camera.

Setting PTZ-650L3X Pattern

The following steps will show you how to configure our PTZ camera model #: PTZ-LX650L3X. These steps must be executed at the DVR ONLY. It cannot be configured through the WEB Service Interface.

Steps:

a)       Create some PTZ presets in your DVR for this camera. You can create up to 32 consecutive presets. To create presets, simply move the camera to the desired position and go to “set” option under PAN/TILT/ZOOM Controller menu by right clicking with your mouse, then enter the preset number, and then click “set” to store that preset number.

b)       Check all of the presets you created to make sure all of them are working correctly. You can check the presets by going to the “Preset” option under PAN/TILT/ZOOM Controller menu by right clicking with your mouse, and enter the number of the preset you want to call, and then click “preset”. The camera will move based on what you assign on that preset number.

c)        Open the PAN/TILT/ZOOM Controller menu by right clicking with your mouse, then option “Set”, and then enter “242”and click “Set” to activate the pattern feature of the camera. (Nothing will show or happen while you input this number).

d)       Go to “Set” and enter “244” to activate the “rotation speed” of the camera (Nothing will show or happen while you input this number). Choose a number from 224-239 for the desired rotation speed. The speed is measured in degrees/seconds and the preset numbers are the following:

e)       Go to “Set” and enter “245” to activate the “wait time” between presets (Nothing will show or happen while you input this number). Choose a number from 224-239 for the desired wait time. The time is measured in seconds and the preset numbers are the following:

f)        Call each preset you created previously on the camera. You can call the preset by going to the “Preset” option under the PAN/TILT/ZOOM Controller menu by right clicking with your mouse; and input the number of the preset you want to call and click “preset”. We recommend calling each preset consecutively in order, using the first preset number you created, i.e. preset 1, 2, and 3….etc.

g)        Finish your configuration by clicking on “Set” and enter “243”. To start the patterns go to “preset option” and call preset “247” to start the pattern. If you would like to stop the pattern at any time you can move the camera to any position you like; after a few seconds of inactivity the camera will reinitiated the pattern again, or if you want to stop this pattern completely, just call preset “248” to stop the pattern.